3. Installing the tap and fixing the hoses

Place the O-Ring (black sealing ring) on the hole for the tap. Guide all hoses of the tap through the hole and place the tap on the O-Ring. To mount the tap, bring the fastening set together as shown in the film under the sink, pass through all the connections and hand-tighten the screw connection. Check the correct alignment of the tap and tighten the screws on the fastening set with a screwdriver.

If you are installing a tap with a pull-out mousseur, now screw the click adapter onto the hose end piece of the flexible hose and attach the hose weight. Click the click adapter onto the copper pipe of the tap. Check the hose weight for correct fit and finally fasten it.
Tip: Before fixing the weight, test the rinsing spray return by pulling it out and returning it several times.
Now you can insert the blue hose firmly into the adapter.

Place the strainer and seal on the angle valve of the cold water connection as shown in the film. Now, screw the T-piece onto the angle valve, tighten it (19 mm nut) and connect the upper opening of the T-piece to the cold water hose of the tap. The hot water hose is installed simply by screwing the 19 mm nut onto the angle valve of the hot water connection.