6. Configure the gas bottle and the filter with the cooler
Required time: 1 Min.
Resetting the CO2 display
To configure the gas bottle with the cooler, press the right button on the cooler until the display flashes. Then confirm again by briefly pressing the right button. The CO2 display is now reset.
System setting
To configure the filter with the cooler, enter the carbon hardness values already determined into the system. The enclosed installation manual shows you which setting to make on the cooler for which water hardness. For example, if your water hardness is 15° dKH, the setting would be F7 and L0 for the S-Size filter. The F and L values are indicators for determining the possible water withdrawal quantity. To enter the values into the system, press the middle button until the display flashes. Change the F value by briefly pressing the middle button until the desired value appears, then hold it down until the L value appears. Now proceed in the same way and keep the button pressed for a long time when the desired L-value is reached.
Conclude with a functional test
To complete the installation, carry out a final function test.
Tip: The system needs at least 24 hours to cool down completely before the full CO2 content is permanently bound in the water.